North American Network Operators Group|
Date Prev | Date Next |
Date Index |
Thread Index |
Author Index |
Re: About Cisco NM-2FE2W-v2
- From: Andrew D Kirch
- Date: Tue May 16 11:40:48 2006
Md. kamal Hossain wrote:
Hi allWow, where to start on this one. I didn't realize this was Cisco's
post-sales support line. Further, I don't think a Cisco 2851 exactly
constitutes core network operations. In the future you would probably
be better off with a cisco-related IRC channel, or web board. That
being said, I'll see if I can't field this real quick.
The 2851 is not powerful enough to route 1 port of 100bT Ethernet let
alone 4. What feature set is your IOS revision? Without knowing that I
doubt anyone could even begin to troubleshoot this issue.
Have you checked to make sure the NM-2FE-2W is compatible with your
router AT ALL? After reading the "Relevant Interfaces and Modules"
documentation at cisco.com I do not see this module being used with 2800
series routers, or it's predecessor, 2600 series routers for that
matter. This is of course all publicly available documentation.
Everything I've seen points to them working only with 3600, 3700, and
possibly 3800 series chassis.
My best suggestion would be to pack up your router, and the network
module and send them to a good home with a caring network admin to tend
to them. If you would like, please contact me off-list as I've been
known to provide shelter to abused and mistreated routing gear.
I purchase a Cisco-2851 and NM-2FE2W-v2 module because i need 4
Fastethernet interface but when i plug the module IOS don't detect the
module.Is there any specific IOS for the NM-2FE2W-v2 module?.now IOS
version is 12.3.If any one have any idea pls reply me.
This message has been scanned for viruses and
dangerous content and is believed to be clean.