Merit Network
Can't find what you're looking for? Search the Mail Archives.
  About Merit   Services   Network   Resources & Support   Network Research   News   Events   Home

Discussion Communities: Merit Network Email List Archives

North American Network Operators Group

Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical

Re: routing sniffed traffic

  • From: Nils Ketelsen
  • Date: Fri Oct 08 10:14:25 2004

On Thu, Oct 07, 2004 at 09:43:47PM +0100, Stephen J. Wilcox wrote:

[switching/routing traffic from a passive tap]

> Hi Peter,
>  if you are feeding this into a switch you should be able to switch it
> just like the real traffic.. ie plug your fibers into gbics on
> whatever switch you want to use, i dont see any special requirements for
> this application

I have no practical experience on that, I always used the monitor directly
on the Tap, but I see a theoretical problem: Where does the switch switch
it to? The Target MAC of the packet coming from the Tap will
be still pointing to the device in the production network. 

The switch in the management network will not know where to switch it to,
as there is no device with the same mac in his ARP table.

If you want to route it you will run into the same problem: The copied
ethernet frame is not addresses to the router in the monitoring network,
so it will not accept the Ethernet frame.

Maybe you could do something with faking the MAC on the router
in the monitoring network to be the same as the MACaddress of the target
in the production network, but it feels like a dirty hack. 

Or am I missnig something obvious here?

Nils




Discussion Communities


About Merit | Services | Network | Resources & Support | Network Research
News | Events | Contact | Site Map | Merit Network Home


Merit Network, Inc.