Merit Network
Can't find what you're looking for? Search the Mail Archives.
  About Merit   Services   Network   Resources & Support   Network Research   News   Events   Home

Discussion Communities: Merit Network Email List Archives

North American Network Operators Group

Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical

Re: need routed configuration help

  • From: Brian Whalen
  • Date: Tue Jan 15 23:39:42 2002

if youre doing a static route, no need for routed.  As root, fire uo
/stand/sysinstall, select post install config, network interfaces, the one
you want, and have at it.  Its a fill in the blanks screen.

Brian "Sonic" Whalen
Success = Preparation + Opportunity


On Tue, 15 Jan 2002, Alex Melkomukov wrote:

>
> Hello everyone.
>
> I'm not sure if this is the correct list, but I was informed that this list
> is where all of the routing experts can be found, so I am sending this plea
> for help to this list.
>
> Basically, I need to confirm some configuration information and make sure
> I've set up everything properly.  I am seeing some very strange behavior
> and need to rule out local misconfiguration as the cause.  I am not a
> routing expert, so I need confirmation.
>
> We had to configure a customer's server to function in a co-location
> facility (not of our choosing) that has a gateway IP address that is
> outside of the locally defined network block (Class C).
>
> The OS is FreeBSD 4.4.  I did some digging and discovered that I needed to
> enable 'routed' and create some static routes to the gateway IP outside of
> the local network block to be able to reach the Internet.
>
> I uncommented the
>
>     defaultrouter="5.6.7.1"
>
> entry (IP has been changed to protect parties involved) in the rc.conf file
> and added the
>
>     router_enable="YES"
>
> entry.  I then added the following entries to the rc.local file:
>
>     route add default -interface 1.2.3.100 -netmask 255.255.255.252
>     route add -net 5.6.7.1 -interface 1.2.3.100 -netmask 255.255.255.252
>     route add default 5.6.7.1
>
> I came up with these routes by trial and error, and am not convinced that
> these are the correct entries to use.
>
> I can reach the Internet and the nameserver (which is also outside of the
> local network block), and can ping and traceroute without any problems.
>
> But,...  every once in a while certain programs start timing out and/or
> take a really long time to respond (to the point of failure due to time-out
> on the other end).  Some of these programs are telnet, ssh, ftp, radius.
>
> Other programs/protocols (such as http traffic) do not display the same
> behavior.
>
> So, I am seeking advice on how to configure static routes correctly and/or
> if some other issues may be causing this strange, intermitten behavior.
>
> Please let me know if I implemented this incorrectly...
>
> am
>    __________________________________________________________________
>    Alex Melkomukov                               amelkomukov@navi.net
>    Navi.Net                                       http://www.navi.net
>    618 NW Glisan St., Ste. 101                     voice 503-517-8866
>    Portland, OR  97209 USA                           fax 503-517-8868
>    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>





Discussion Communities


About Merit | Services | Network | Resources & Support | Network Research
News | Events | Contact | Site Map | Merit Network Home


Merit Network, Inc.