Merit Network
Can't find what you're looking for? Search the Mail Archives.
  About Merit   Services   Network   Resources & Support   Network Research   News   Events   Home

Discussion Communities: Merit Network Email List Archives

North American Network Operators Group

Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical

RE: Internet Building topology

  • From: Chris MacFarlane
  • Date: Tue Aug 05 20:38:50 1997

With the information provided it seems the you should concentrate on logical connections first then work out the physical location of the equipment as a secondary matter.  For all you know you may end up have one central equipment room on one floor.  Anyway from what you have said you currently have the need for two subnets.  

Your first consideration should be future flexibility.  To maximize this you need to determine how many addresses (hosts) are needed in each subnet.  Make your subnets fit the largest number of machines in the largest segment (make sure you look at near future needs).  For example if you need 26 hosts use a /27 not a /26  Next is do you require a dynamic routing protocol (in you example it would seem you do not - only one router)?  Assuming you need less then 62 hosts in each subnet and have no need to use dynamic routing (RIP, OSPF or ISIS) you should subnet with /26.  Don't assign the first and second subnet (eg .0/26 and .64/26).  Use the fist and third subnets (eg .0/26 and .128/26)  This way you can move the netmask if required.

Next you need to determine a host number policy (something simple)
- host start at the bottom
- servers start from the end
- always avoid logical network and broadcast addresses

I have assumed that you have two ethernet ports on the router (or you would have less reason to subnet at all)

|---------------------| .0/26
	|
    .1/26	|
	R--------------> to ISP 
.129/26	|
	|
|--------------------| .128/26

If you would like further assistance e-mail me directly

Hope this is a helps, with the info provided this is all the help I can be

Rgds

Cjm



-----Original Message-----
From:	Stephen Balbach [SMTP:stephen@clark.net]
Sent:	Sunday, August 03, 1997 5:08 PM
To:	nanog@merit.edu
Subject:	Internet Building topology


Hi,

I am designing an "Internet Building" concept using ethernet. Below is a 
model using 2 cisco Catalyst 1912's (12 port ethernet switch) and a 
cisco 2501.

Switch 2 is on the 2nd floor and Switch 1 is in 1st floor. Does this 
look like a viable topology? Are there other/better ways to approach 
this for scaleability? Thanks for any ideas/experiences.


        x.x.x.0  /26 (Customer 2nd floor)
        |
        |   x.x.x.64 /26 (Customer 2nd floor)
	|   |
        |   |
	Switch 2 (2nd floor)			
	A | B | C	VLAN 1 = A+C 
		|	VLAN 2 = B+C 
		|
		|
		| (cable drop between 1st and 2nd floor)
		|
		|
		|
	Switch 1 (first floor)
	A | B | C	VLAN 1 = B + C
            |		
	    |
	cisco (first floor)
	ip secondary x.x.x.0  /26
	ip secondary x.x.x.64 /26
            |
            |
	    |
       T1 to Internet
	    |
	    |






Discussion Communities


About Merit | Services | Network | Resources & Support | Network Research
News | Events | Contact | Site Map | Merit Network Home


Merit Network, Inc.